-40%
ATLAS Transfer Case Rear Support Ring DIY Kit
$ 47.51
- Description
- Size Guide
Description
Fast Fabrication Atlas Transfer Case Support Ring DIY kitKit fits all transfer cases with a 3.900" output diameter
Also fits Dana 300 and NP231 with Advance Adapters HD Tailshaft Conversion
The DIY Kit Includes the following:
1/2" thick precision laser cut support ring with laser etched cut guides
2 - 3/16" thick mounting tabs; the bottoms were left flat intentionally so the user could fishmouth for any size tubing
2- 3/4" OD x 1/2" ID x 1-1/2" long steel bolt sleeves
1-3/4" OD x 1/4" wall DOM steel tube 2-1/2" long
Energy Suspension polyurethane bushings w/ sleeve
1/2" Grade 8 hardware with lock nuts
To install:
Weld the sleeves to the sides of the support ring
Using the laser etch cut guides, cut each side of the support ring and sleeves
Weld the bottom of the support ring to the DOM bushing sleeve, you may modify the height if necessary to get the correct offset
*THE INSTALLED PICTURE SHOWN IS THE PROTOTYPE ON MY OWN PERSONAL RIG THAT HAS BEEN INSTALLED FOR CLOSE TO A YEAR.